Strukturgeräte

RED CREEK RILLING TOOLS ermöglichen es dir, den Gleiteffekt deiner Ski durch eine handgefertigte Struktur auf dem Belag fein abzustimmen – genau wie im Weltcup.

Ein Steinschliff bildet die Grundlage, während die Handstruktur den Ski an die jeweiligen Schneebedingungen anpasst. Je wärmer und feuchter der Schnee, desto gröber sollte die Struktur sein. Bei Kälte verwendet man eine feinere. Einfach in der Anwendung, wirkungsvoll und unverzichtbar für alle, die höchste Leistung und das perfekte Renngefühl suchen.

Understand Red Creek XC Rillers

RC-2069

Coarser than +15°C/-5°C Christmas tree. To be used at temperatures around +15°C to -5°C, coarser snow, man-made snow, and wet snow. If plus degrees, press hard. Often complemented with Linear 1 mm, Linear 2 mm, and/or Linear 3 mm. If the temperature is minus degrees, apply moderate pressure. Then mostly used on the last part of the ski.

RC-2034

To be used at temperatures between +15°C and -5°C, coarse snow, wet snow, and man-made snow can, by advantage, be complemented with Linear 1 mm or Linear 2 mm when plus degrees.

RC-2082

To be used at temperatures between +5 and -5°C, wet snow and fine-grained snow. It may be complemented with linear structures.

RC-2084

To be used at temperatures between O°C and -6°C.

RC-2086

To be used at temperatures between -5 and -10°C. Opens the hard glossy base surface. Mostly used when the snow is fine-grained.

RC-2035

To be used at temperatures between O°C and -10°C, coarse snow, man-made snow, and eventually new snow. Press harder/deeper when the conditions are warmer.

RC-2083

To be used at temperatures between -5 and -15°C. Fine Christmas tree. Opens the hard glossy base surface. Mostly used when the snow is fine-grained.

RC-2036

To be used at temperatures between -5°C and -20°C. Very fine oblique cut structure. Opens the hard glossy base surface. To be used when the snow is dry, cold, and fine-grained.

RC-2085

To be used when the snow is cold, dry, and fine. As well, in combination with other Red Creek Rilling tools, depending on the temperature.

RC-2033

To be used in warm conditions combined with +15/-5 or Coarse. It can also be used in colder conditions, but then with less pressure.

RC-2037

To be used in wet conditions, combined with +15/-5 or Coarse, also combined with Linear 1 mm. It can also be used from the middle of the ski and backwards in temperatures just below the freezing point.

RC-2080

To be used in extremely wet conditions combined with Coarse or +15/-5 and Linear 1 mm and/or Linear 2 mm.

RC-2247

Prevent the Straight/linear riller from rolling and start cutting deeper into the ski base.

RC-2038

To be used when loose tracks and part of tracks occur, and when snow is falling. To be used always when skating (The tracks get looser during the race).